| CONSTRUCTION |
| Moulded, glass reinforced plastic housing. Die and brake formed, code gauge cold rolled steel reflector and ballast cover. Continuous poured in place polyurethane gasket. Diffuser flange fits into the gasketed retention slot providing a continuous seal, and is held in place with retaining latches. Holes on each end are 7/8" nominal diameter and are provided with two EPDM rubber caps. |
| MOUNTING |
| Offset mounting pads which keeps luminaire level and slightly off of mounting surface, are formed within the housing. Optional suspension set for chain mounting available. |
| FINISH |
| High reflectivity coated, reflecting surfaces for improved efficiency. |
|
| OPTICS |
| Standard diffuser is high impact acrylic with textured pattern designed for high efficiency while providing reduced glare. Smooth surface faces outwards. Polycarbonate diffusers are available. |
| ELECTRICAL |
| All electrical components are CSA or UL approved. Ballasts and lamp holders are replaceable without removing the luminaire from the mounting surface. Standard electronic ballasts are instant start, with a THD of less than 20%. See Product Selection for optional ballasts. The standard voltage is 120V, 60 Hz, or as specified. |
| APPROVALS |
| Approved to CSA and UL standards. (UL, or equivalent, marked only when specified.) CSA - CUS approved. |
|
| OPTIONS |
|
Clear textured polycarbonate lens with linear ribs.
Polycarbonate rotary lock lampholders.
Stainless steel latches.
|
| OPTIONAL ADDERS |
|
Suspension set for chain mounting.
Tandem liquid tight connector for row mounting luminaires.
Liquid tight strain relief cord connector.
|
|
