| FEATURES |
| IP67 - Ingress Protecton Rating. |
| Shallow and narrow design. |
| Lightweight, impact resistant polycarbonate housing. |
| Acrylic DR diffuser standard, polycarbonate optional. |
| Advanced high efficiency T5 technology. |
| Dust and moisture resistant. |
| Available with 1, 2 or 3 lamps. |
| Continuous poured in place gasket. No joints to open. |
| Suitable for indoor or outdoor applications. |
| High efficiency VF-1, (95%) optical reflector available. |
| APPLICATIONS |
| Ships and marine vessels. |
| Carwash |
| Parking Garages |
| Hospital |
| Garage and Workshops |
| Canopies |
| Cold Storage |
| Food Processing |
| Wet and Damp Environments |
| Dusty Environments |
|
| FV - FIVE VAPOUR |
| Vapour Proof Luminaire |
|
| APPLICATION FEATURES |
| Specification grade, impact resistant, fluorescent enclosed and gasketed fixture. For use in both indoor and outdoor applications where dust and moisture resistance is required. Will withstand temporary immersion in water. Suitable for surface,suspended or wall mounting individually or in continuous rows. |
 |
| CONSTRUCTION |
| Moulded, U.V. stabilized polycarbonate Die and brake formed, housing. code gauge cold rolled steel ballast cover. Precision formed, optional, heavy gauge 99.85% pure 95% reflectance aluminum reflector. Continuous poured in place polyurethane gasket. Diffuser snaps into housing for easy installation and re-lamping. Diffuser flange fits into the gasketed retention slot providing a continuous seal, and is held in place with retaining latches. Latches are moulded integral to and as part of the housing. Holes on each end are 7/8" nominal diameter and are provided with two EPDM rubber caps. Aligning tabs are moulded onto each end, so that luminaires may butt together for mounting into continous rows. |
| MOUNTING |
| Offset mounting pads which keeps luminaire level and slightly off of mounting surface, are formed within the housing. Optional suspension set for chain mounting available. May be continuous row mounted if used in conjunction with optional tandem liquid tight connector. |
| FINISH |
| Powder painted high reflectance white ballast cover. |
|
| OPTICS |
| Standard diffuser is high impact acrylic with textured pattern designed for high efficiency while providing reduced glare. Smooth surface faces outwards. Polycarbonate diffusers are available. Optional VF-1 reflectors are made of specular low irridescence, anodized aluminum with a reflectivity of 94% or better. |
| ELECTRICAL |
| All electrical components are CSA or UL approved. Lamp holders are rotary-lock, snap-in place, minature bi-pin. Electrical bonding and support of cover, where electrical devices may be mounted, is provided. Ballasts and lamp holders are replaceable without removing the luminaire from the mounting surface. Standard ballasts are electronic rapid start for T5 lamp configurations. See Product Selection for optional ballasts. The standard voltage is 120V, 60 Hz, or as specified. |
| APPROVALS |
| Approved to CSA and UL standards. (UL, or equivalent, marked only when specified.) CSA - CUS approved. |
|
| OPTIONS |
|
Clear textured polycarbonate lens with linear ribs.
|
| OPTIONAL ADDERS |
|
Liquid tight strain relief cord connector.
Tandem liquid tight connector for row mounting luminaires.
Suspension set for chain mounting.
VF1- 95% reflectance, specular anodized aluminum reflector.
|
|
|
